Currie Jeep Wrangler JK F9 Fabricated 9" 1-Ton Front-End Unit - Bolt-In
The F9 fabricated 9" frontend assembly for the 2007 and up Jeep Wrangler JK includes the complete housing with the Hi-Form 50 steel housing center, 3" x .375" wall d.o.m. steel tubes, 1 ton inner knuckles, and all new heavy duty Currie Jeep JK suspension brackets mounted. Upper control arm brackets are equipped with Johnny Joint® rod ends for maximum articulation. Axles shafts are the Currie performance 4340 35 spline inner and outer with Spicer 1480 u-joints. Outer assemblies include 1 ton outer knuckles featuring Currie "high steer" steering arm and ball joints installed, Currie exclusive 1 ton unit bearings with 5 on 5 1/2" wheel bolt pattern and JK tone rings allowing for ABS and ESP retention, 13" vented rotors (over 1" greater diameter than stock for increased braking), zinc plated caliper brackets that allow the use of the stock JK front calipers, Currie drive flanges or premium manual locking hubs, and our heavy duty 1 3/8" o.d. 4130 chrome moly tie rod with tie rod ends.
The only parts needed to complete this unit is a 9" high pinion 3rd. member, and assembly of the unit! Your JK's stock calipers transfer over!Shipping Notes:
Estimated shipping cost for this item is $300.
The actual shipping cost may vary depending on your location.
Please call 805-783-2060 if you have any questions.