Details

Poison Spyder Ricochet Rockers™ are built with the same hardcore toughness as its counterpart the Rocker Knocker™, with the added utility of a combination 5" step and slider. This rocker protection is the pinnacle of hardcore body armor protection, style and convenience. The Ricochet Rocker™ is available for Jeep TJ, Unlimited, YJ, CJ7 and CJ8.

Ricochet Rocker™ protection can be used alone or in combination with Crusher Corners™. The two body armor pieces fit together at the rear flare area. Used together, Ricochet Rockers and Crusher Corners™ form the ultimate protection, guarding your Jeep's body from the front wheel well to the tailgate. Ricochet Rockers™ are secured with counter sunk 3/8" stainless hardware, supplied in the kit with detailed installation instructions.

Ricochet Rockers™ have a distinguishing 5" dimpled plate that acts as a step and a stout reinforcement for the slider. This makes the Ricochet Rocker™ protection a very effective armor addition and an effective pivot for getting into your rock chariot. Jeep TJ,YJ and CJ7 have three dimples, Unlimited and CJ8 have four. With the dimple protrusions pointing upward, they give the extra benefit of increased foot traction when entering or exiting the vehicle, even with boots covered with snow or mud.

Ricochet Rockers™ are further reinforced with additional bracing below the dimpled step. The dual tube support and slider bar is constructed of 1.5" DOM tubing, the step and corner gussets are CNC laser cut from 3/16" steel plate, and brake-formed to act as their own gusset for strength and a clean appearance. Everything is professionally welded and comes to you ready to paint and bolt on.

For installations in which you would like to protect the paint underneath the Ricochet Rocker™, as well as provide a measure of vibration absorption, an optional Rubber Liner is offered, precisely cut to fit between the Rocker Knocker and the Jeep's body. Be sure to order these separately, as they're not included in the standard Ricochet Rocker™ package.

Part #Application
POI-11-50-010Jeep CJ-7
POI-12-50-010Jeep CJ-8
POI-13-50-010Jeep YJ w/ Stock Opening
POI-13-50-050Jeep YJ/CJ-7 w/ TJ Opening

Note:



Drilling required



The side mounted body bushing must be shortened by 3/16" to accommodate the rocker

CJ/YJ/TJ Installation Instructions



LJ Installation Instructions

Reviews

Ratings & Reviews

Be the first to write a review