Description:
CST Performance Suspension's 7" lift kit was designed not only to give you 7 inches of lift but also to increase the vehicles over all ground clearance. CST's top of the line performance lift coil springs will keep you rollin smoothly down the road, and the big taper ball joint sitting inside of it's double sheer ball joint pocket will keep ball joint problems down to a minimum. For the crew cab model pick ups we recommend the use of a 4" off set pin block which will keep the rear end forward, preventing the drive shaft from pulling out of the transmission to far. The rear of these trucks have a long one piece drive shaft and a cross member that runs directly underneath it. If you use a 4" block the shaft is lowered down far enough to where it could have a chance of hitting the factory cross member. To insure the drive shaft does not contact this crossmember you should use a 27" extended shock to stop any contact when the suspension is hanging down fully extended.
Select tabs below for more information.
- Features
- Inlcuded Components
- Optional Upgrades
- Designed to fit 305/70/17 Tires wi/ 8" wide wheels (max 4.75 backspace)
- Upper control arms utilize double sheer ball joint pockets including heavy duty large taper ball joints
- All parts covered in a high quality gloss black powder coat finish
- Ability to be put back to stock
- 4" Spindles
- 3" Performance Lift Coils
- 4" Fabricated Lift Block
- U-Bolt Kit
- CSS-C1-2 - 4" Lift Spindle Upright
- CSS-C2-1 - Upper Control Arm Kit
- CSC-C3-1 - Lift Coil Spring
- CSB-N14-4 - 4" Fabricated Lift Block (offset pin)
- CSU-C15-12.5 - 12.5" U-Bolt Kit w/ Nuts and Washers
- BRAKE LINES - Steel Braided Brake Lines
- CSJ-C18-7 - CST Pro Joint Upgrade
Shock Options:
- CST-CSR-1100 - CST Performance Front Shocks (w/ Torsion Keys Only)
- FOX-980-99-268 - Fox OEM Emulsion Front Shock Pair
- CST-CSR-2950 - CST Performance Rear Shocks
- FOX-980-99-025 - Fox 2.0 Emulsion Rear Shock Pair
|
Notes:
Wheels Must Not Have More Than 4 5/8
Ask For Coil That Fits Your Vehicle Application
Rear Shocks Should Be No More Than 27" Extended Eye To Eye |
