Poison Spyder Jeep CJ/YJ/LJ/TJ Crusher Corners

Poison Spyder Crusher Corners™ are built for the off-road enthusiast who likes to play in the BIG rocks! Crusher Corners™ are a key component in avoiding body damage to your Jeep. Poison Spyder Crusher Corners are CNC laser cut from high strength 3/16" plate steel or rugged lightweight 3/16" 6061-T6 aluminum. The precisely cut pattern isthen carefully roll-formed for a perfect fit to your Jeep's body lines. Crusher Corners™ protect your Jeep from the tailgate all the way to the door opening, in one unbroken curtain of impregnable body armor At the front edge, Crusher Corners™ are precisely cut to integrate with Poison Spyder Rocker Knockers™ or Ricochet Rockers™. All of the bolt holes are countersunk, and the supplied stainless steel flat head cap screws yield a smooth, flat surface to slide over rocks. These Crusher Corners™ feature a smooth side with maximum trail clearance, but Crusher Corners™ with integrated Crusher Flares™ are also available.

Ricochet Rocker™ protection can be used alone or in combination with Crusher Corners™. The two body armor pieces fit together at the rear flare area. Used together, Ricochet Rockers™ and Crusher Corners™ form the ultimate protection, guarding your Jeep's body from the front wheel well to the tailgate. Ricochet Rockers™ are secured with counter sunk 3/8" stainless hardware, supplied in the kit with detailed installation instructions.

Ricochet Rockers™ have a distinguishing 5" dimpled plate that acts as a step and a stout reinforcement for the slider. This makes the Ricochet Rocker™ protection a very effective armor addition and an effective pivot for getting into your rock chariot. Jeep TJ,YJ and CJ7 have three dimples, Unlimited and CJ8 have four. With the dimple protrusions pointing upward, they give the extra benefit of increased foot traction when entering or exiting the vehicle, even with boots covered with snow or mud.

Ricochet Rockers™ are further reinforced with additional bracing below the dimpled step. The dual tube support and slider bar is constructed of 1.5" DOM tubing, the step and corner gussets are CNC laser cut from 3/16" steel plate, and brake-formed to act as their own gusset for strength and a clean appearance. Everything is professionally welded and comes to you ready to paint and bolt on.

For installations in which you would like to protect the paint underneath the Ricochet Rocker™, as well as provide a measure of vibration absorption, an optional Rubber Liner is offered, precisely cut to fit between the Rocker Knocker and the Jeep's body. Be sure to order these separately, as they're not included in the standard Ricochet Rocker™ package.

Note:
Drilling required
Cutting of factory sheet metal required

Installation Instructions