Currie Jeep Wrangler JK RockJock III 1-Ton Front-End Unit - Bolt-In

Currie Jeep Wrangler JK RockJock III 1-Ton Front-End Unit - Bolt-In

Currie Enterprises

The RockJock® III high pinion frontend assembly for the 2007 and up Jeep JK includes the complete housing featuring the 65-45-12 ductile iron housing center (highest ground clearance 60 on the market), AR400 heat treated bottom skid plate allowing the axle to slide over rocks easily, 3" d.o.m. steel tubes, 1 ton inner knuckles, 5/16" thick heavy steel diff cover, yoke (1310/1330/1350 optional), and all new heavy duty Currie Jeep JK suspension brackets mounted. Upper control arm brackets are equipped with Johnny Joint® rod ends for maximum articulation. Axles shafts are the Currie performance 4340 35 spline inner and outer with Spicer 1480 u-joints. Outer assemblies include 1 ton outer knuckles featuring Currie "high steer" steering arm and ball joints installed, Currie exclusive 1 ton unit bearings with 5 on 5 1/2" wheel bolt pattern and JK tone rings allowing for ABS and ESP retention, 13" vented rotors (over 1" greater diameter than stock for increased braking), zinc plated caliper brackets that allow the use of the stock JK front calipers, Currie drive flanges or premium manual locking hubs, and our heavy duty 1 3/8" o.d. 4130 chrome moly tie rod with tie rod ends.

Additional parts needed to complete this unit are a high pinion D60 ring and pinion gear set, D60 35 spline carrier of your choice, and a bearing & set up kit.

Shipping Notes:
Estimated shipping cost for this item is $300.
The actual shipping cost may vary depending on your location.
Please call 805-783-2060 if you have any questions.