Description:
This is the GenRight RBB-1001, a 3/16" thick steel cross member reinforcement kit for the rear cross member on the frame of a Jeep
It is designed to beef-up your existing rear frame member AND body mounts It can also be used as a hi clearance bumper by itself (as seen on RTC-3200 & 3400 tire carriers) or a reinforcement under a rear bumper
As you can see in the pictures, you remove the rear most body mounts and install the plate then slip them back in place
Features:
- C channel design fits over and under frame
- Laser cut and CNC formed into shape for a perfect fit
- Allows you to repair or replace damaged rear frame cross members & body mounts (needed on LJ's)
- Allows you to beef up rear frame section
- Can be installed under an existing rear bumper
- Can be used by itself as a bumper for a better departure angle
- Bolt-on design
- Includes Grade 8 mounting hardware
- Shipped to you un-painted
Kit Includes:
- (1) Full width laser cut and bent rear plate (RBB-1000)
- (2) Outboard rear frame brackets (can not be used on leaf spring vehicles)
- (1) Grade 8, 7/16-20 Hardware kit
Important Notes::
- Requires dropping the gas tank and the drilling of 2 additional holes in the rear cross member to properly mount it on your Jeep
- Optional internal "backing plate" is recommended and available (RBB-1007)
- For proper mounting, it requires removing the fuel tank to drill and access center bolts
- Is NOT a direct bolt-on for CJ's
- If this product is being used under a aftermarket rear bumper to beef up or reinforce the rear cross member, you may have to cut off and re-weld the lower tabs on the rear bumper (if your bumper has these tabs to pick up bottom frame holes)
- Holes in plate fit the LED-1500 back up lights
|
