Artec Industries Raised Tracbar Bracket for TJ Front Axle

This heavy bracket is designed to replace the factory trackbar bracket for improved link geometry with crossover steering on the front 30 and Rubicon 44 axles in the Jeep TJ, LJ, XJ, and ZJ. If you've changed your steering, you need to match your trackbar to make it parallel to the draglink. This bracket gives you several options to find the perfect geometry. The 1/4" thick CNC precision cut and formed components of this setup ensure a quality, heavy duty solution.

This heavy bracket is designed to replace the factory trackbar bracket for improved link geometry with crossover steering on the front 30 and Rubicon 44 axles in the Jeep TJ, LJ, XJ, and ZJ. If you've changed your steering, you need to match your trackbar to make it parallel to the draglink. This bracket gives you several options to find the perfect geometry. The 1/4" thick CNC precision cut and formed components of this setup ensure a quality, heavy duty solution.   NOTE: This bracket offers several raised trackbar holes. Every lift is different and some trial and error may be necessary to find the ideal ride. This bracket is NOT bolt on and requires welding. This bracket will also require modifying or fabricating a new trackbar itself since it will be slightly shorter. This bracket attaches to the axle next to the factory coil perch. Joint width is 1.65", so use Artec Industries Narrow Misalignment Spacers with 7/8" Heims if you are building your own Trackbar.

Features:

• 1/4" steel
• CNC laser cut and CNC bent for precise fit
• Engineered using 3D scan files
• Replaces factory bracket
• Engineered for lifts 3” or higher
• Raises roll center for increased stability
• Improved ground clearance
• Made in the USA

Notes:

• This bracket offers several raised trackbar holes. Every lift is different and some trial and error may be necessary to find the ideal ride. This bracket is NOT bolt on and requires welding. This bracket will also require modifying or fabricating a new trackbar itself since it will be slightly shorter. This bracket attaches to the axle next to the factory coil perch.
• This kit requires general welding and fabrication skills. Welding should only be done by a competent welder. Artec Industries implies no guarantees or warranties and is not liable for improper installation.