Trail-Gear Longfield Nissan Patrol Birfields

The Longfield Gun Drilled 30-Spline Birfields are made out of 100% chromoly and are precision polished to remove any imperfections that may cause stress risers. The internals of the birfield are also made from 4340 chromoly and are dual heat treated for superior strength.The birfield has a M8 grease zerk at the end of the stub shaft and is gun drilled through the center of the birfield to allow for grease to pass through the zerk fitting and into the internals. This will save you precious time by eliminating the need to disassemble your axle just to service your birfields.

The Gun Drilled 30-Spline Birfields also have a shallow relief near the splines on the stub shaft known as a Machined Spline Saver. The Machined Spline Saver eliminates stress concentrations caused by grooving from the tool that makes the splines on the stub shaft. The stress concentration from the spline groove is a common failure point on birfield stub shafts.

Note: The spline count on the stub shaft is 31-spline and 30-spline on the inner star.

Part #	Fits
TGI-300793-KIT	Nissan Patrol GR (Y60) 1987-1997 (All Engines)
TGI-300793-KIT	Nissan Patrol GQ 1987-1997 (All Engines)
TGI-300793-KIT	Nissan Patrol Safari 1987-1997 (All Engines)
TGI-300793-KIT	Nissan Safari 1987-1997 (All Engines)
TGI-300793-KIT	Ford Maverick 1988-1994 (All Engines)
TGI-300807-KIT	Nissan Patrol GR (Y61) 1997-2013 (All Engines)
TGI-300807-KIT	Nissan Patrol GU 1997-2013 (All Engines)
TGI-300807-KIT	Nissan Patrol Y61 1997-2013 (All Engines)
TGI-300807-KIT	Nissan Safari 1997-2004 (All Engines)
TGI-300807-KIT	Nissan Patrol Super Safari 1997-2013 (All Engines)

*Made in the USA*

require([ 'jquery' ], function ($) { $(document).ready(function(){ }); });