RockJock Trac Bar Relocation & Steering Stabilizer Shock Mount Bracket (High Steer) for Jeep JL / JT

The RockJock® Trac Bar Relocation & Steering Stabilizer Mount Axle Bracket Kit for all Jeep® JL & JT models is designed specifically to be used in conjunction with RockJock's High Steer Knuckles.

Given the dramatic changes in geometry high steer knuckles impose, this axle bracket easily bolts on to your factory axle and provides you with geometry correction for your trac bar to prevent you from incurring any bump steer after installing the high steer knuckles. The stabilizer shock mount portion of the bracket gives you an easy bolt up anchor point for your shock that sets the shock at a considerably higher position than stock, behind the raised tie rod, to protect it from rock bashing!

RockJock recommend buying this bracket in RockJock's complete CE-440001-101 High Steer Knuckle Kit so that you are ensured a complete system that includes everything you need to get the job done. The use of RockJock's CE-9120FJL forged, “T-shaped” front trac bar is also strongly encouraged, so that all components nest together for maximum up travel as RockJock have intended.

Fitment:

• Jeep Wrangler JL Unlimited (4-door)
• Jeep Wrangler JL (2-door)
• Jeep Gladiator JT
• Fits all listed vehicles below, granted they retain the factory front differential.

Fitment Notes:

• For use on any factory JL or JT front differential.
• This bracket is designed around mono-tube stabilizer shocks only. Twin tube and thru-rod dampers will intersect with other components.

Includes:

• Trac Bar & Steering Stabilizer Mount Bracket (inner & outer brackets)
• All necessary hardware

Notes:

• RockJock recommend buying this bracket kit in RockJock's complete CE-440000-101 High Steer Knuckle Kit so that you are ensured a complete system that includes everything you need to get the job done.
• For optimum performance of this kit, RockJock recommend the use of RockJock's CE-9120FJL trac bar and RockJock's CE-107101-101 adjustable bump stop kit.
• This bracket is intended for use in conjunction with factory or factory replacement single mono-tube stabilizer shocks.
• One hole must be drilled in the bottom of the factory trac bar axle bracket for installation of this bracket kit. A drilling jig is included in this kit (photo 5 in gallery).